You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This board does work perfectly, it hasn't any electrical issues.
However, it has some minor mistakes/imperfections:
the labelling of the SWD port is incorrect, it should be SWDIO,GND,SWCLK,3.3V (instead of GND,SWCLK,SWDIO,3.3V)
the two big solder holes for the battery cable are missing solder rings on the bottom
the sequence of pins of the I2C#2 port is reverse as compared to that of the MPU I2C port (hence, and IMU module connected the MPU port MUST NOT be connecetd to the I2C#2 port, and vice versa)
Obviously, these points will be taken care in the next release.
The text was updated successfully, but these errors were encountered:
This board does work perfectly, it hasn't any electrical issues.
However, it has some minor mistakes/imperfections:
Obviously, these points will be taken care in the next release.
The text was updated successfully, but these errors were encountered: