add xsns_102_ld2410s.ino

[md5sum-as]

Description:

Related issue (if applicable): fixes #

Checklist:

• The pull request is done against the latest development branch
• Only relevant files were touched
• Only one feature/fix was added per PR and the code change compiles without warnings
• The code change is tested and works with Tasmota core ESP8266 V.2.7.8
• The code change is tested and works with Tasmota core ESP32 V.3.1.0.240926
• I accept the CLA.

NOTE: The code change must pass CI tests. Your PR cannot be merged unless tests pass

HLK-LD2410S 24GHz smart wave motion sensor
Attention!
This module works with HLK-LD2410S devices.
The module does not support another HLK-LD2410 devices.

Available commands:
LD2410S_Parameters - showing previously received parameters
LD2410S_ReRead - reread common, trigger and hold parameters from device
LD2410S_SetCommon 0-16,1-16,10-120,5-80,5-80,5/10 - set common: near door, far door, hold_time, status_freq, distance_freq, response_speed
LD2410S_SetTrigger n,n1..n16 - set trigger values (16)
LD2410S_SetHold n,n1..n16 - set hold values (16)
LD2410S_Out_Mode 0/1 - set device output mode 0-short (only distance and 0/1 - no people, 2/3 detect people), 1-normal mode (add energy values per door)
LD2410S_AutoUpdate 2,1,60 - start autoupdate trigger and hold thresholds/ Params: trigger_scale,retension_factor,scan_time
LD2410S_Follow 0/1 - if 1 then start reports every seconds